Cwejman

The Ai-2 is an audio interface which allows you to easily connect modules with mixer consoles, tape recorders or any kind of DAW with XLR balanced inputs and outputs. The gain compensation is provided by the GAIN TRIM knobs in the range of 20 dB....

The ATT-4 consists of four independent manual attenuators and it is ideal as interface between modulation sources and modules with direct CV inputs (not attenuable CV inputs). It has additionally LEVEL/BIAS SHIFTERS which converts nominal signals ±5...

The CRV-24 is a 4-band crossover with 24 dB/octave slope for all four bands. Crossover frequencies can be controlled manually and by attenuable CV signals. The incoming signal INPUT is split into four bands; LP (low pass filter), MID1 (high/low...

The new D-LFO with LED's is identical to the original with the exception of 2 added LED's. The D-LFO consists of two identical low frequency oscillators. LFO2 can be internally synced to LFO1 by an internal switch. The internal trip point controls...

The FSH-1 is a frequency shifter module based on the RM-2S Ring Modulator module. The main purpose with the frequency shifter is to make frequency shift up and down for processed audio signal. Two signal sources are needed; the carrier and the...

The MMF-1 is an extremely flexible filter. The variable SPACING (bandwidth) and 2 variable resonance peaks make it possible to create various vocal-like sounds. The circuit design is 'state of the art' analog and the results are truly impressive. ...

Back in stock! The MMF-6 is a multi mode filter with six outputs, first three from the left; "clean" low pass, band pass and high pass. low- band- and high pass to the right are processed by three separate (for every output) saturation circuits with...

The NS-4 is a true analogue noise generator module with four noise/random signal outputs; Sample and Hold (S/H), White, Pink and Red. S/H The S/H generates a random signal controlled by two voltage controlled parameters; RATE and LAG (slew rate)....

Four VCAs are controlled in two pairs VCA1 / VCA2 (X) and VCA3 / VCA4 (Y), panning in X and Y. The Aux input is connected to all VCAs' inputs, so by controlling X and Y (manually or by CV) the signal connected to the Aux input will be presented in...

Cwejman RG-6 Random Generator - information to come...

14-stage stereo image phaser. It consist of two identical voltage controlled all-pass filters with seven notches stretched over the whole audio range which ensures constant phasing effect. The all pass filters are combined with original audio...

The VC-FCS is a unique stereo forward compressor in the sense that all compressor parameters can be voltage controlled from the external modulation sources by CV inputs. It gives a lot of possibilities for an instant change of compressor's character...

The VCA-4MX consists of four individual voltage controlled amplifiers. All amplifiers are identical and work in a semi-logarithmic mode. Amplifiers accept both DC and AC signals. The VCA-4MX has eight outputs for maximal flexibility; all amplifiers...

These latest VCO-2RM modules are now eggshell white. The Oscillators are the main sound sources of the instrument. VC0-2RM is equipped with seven waveforms, LFO mode, sync and waveform outputs are routed to a DC coupled ring modulator (RM). The...

The VM-1 is a complete voice module with an oscillator, multi mode filter, amplifier and 2 envelope generators. The OSCILLATOR can produce seven basic waveforms. The pitch is controlled manually by the 'COARSE' and 'FINE TUNE' controls, and also by...